Kemo – M – Kemo M – 6A Solar Charge Controller/Regulator, 12V, 60Wp – This solar charging controller module can be connected between a 12V DC. Solar Charging Controller Module. Solar / Charging / Controller Module. Solar Charging Controller Module 12VDC A. Part No: KEMO M Kemo Electronic M Module, Solar Charge Controller: : Electronics.
|Published (Last):||12 June 2016|
|PDF File Size:||13.43 Mb|
|ePub File Size:||11.19 Mb|
|Price:||Free* [*Free Regsitration Required]|
Document Actions Send this Print this. When the accumulator is. Do only connect solar cells up to a power of 60 W as current source! The four different types of cookies are: Alternatively use our Quotation page.
After wiring everything according to the drawing and description, the device is ready for operation.
LEDs indicate ‘battery full’ approx.
Strictly Necessary cookiesFunctionality cookiesPerformance cookies and Advertising cookies. Connect a safety fuse 10 A in the lead between the accumulator and charging controller not enclosed! Do not use stronger current sources and no transformers, battery chargers, accumulators, wind wheels, etc.
Personal tools Log in.
Re-reeling orders placed after This solar charging controller module can be connected between m194 12V DC solar cell open circuit voltage 14 to 30V DC and a 12V DC battery to prevent overcharging of the battery.
A power MOS transistor that switches almost lossfree is used as circuit element. The energy yield will be reduced this way.
The following applies here: The module is to be mounted as close as possible to the accumulator or keml of accumulators, respectively, to be charged ideal: This module is an electronic switch which switches on the connection to the solar cells if the accumulator is empty and switches off again when the accumulator is fully charged.
Questions Ask a Question Be the first to ask a question.
The cable towards the kkemo cells may be of any length. To use this facility please Sign In. This will neither damage the kkemo nor the charging controller, but it causes a frequent charging interruption because a higher voltage is measured due to the additional line resistances and the smaller proximity to the solar cell, and the charging controller switches off earlier. So you should lead the cable to the charging controller the shortest possible way and use cable which is not too thin 0. Unfortunately re-reeling is not available at the present time for this item.
Kemo M149 – 6A Solar Charge Controller/Regulator, 12V, 60Wp
If the cable is longer or has a smaller cross section, respectively, the measuring result of the battery voltage measurement will be changed due to the higher internal resistance of the cable.
Reviews Write a Review Be the first to submit a review.
M Solar charging controller 12 V/DC, 6 A / 10 A
You may also like The cross section of the cable between the charging controller and accumulator should be at least 1,5 qmm. Battery inrush voltage Approx. The longer the cable, the higher the line loss.