JIS B 8270 PDF

Jis b pdf. DownloadJis b pdf. Free Pdf Download Computer Experience. Intermediate Location Minnesnowta Type 3 JDBC Driver BDP-BX1 S Find the most up-to-date version of JIS B at Engineering the Appendix 11 of JIS B (Construction of pressure vessel — General . JIS B. (Pressure vessels–General standard) or standards.

Author: Samujind Voodoojinn
Country: Turks & Caicos Islands
Language: English (Spanish)
Genre: Software
Published (Last): 18 March 2006
Pages: 485
PDF File Size: 10.64 Mb
ePub File Size: 13.97 Mb
ISBN: 980-1-43759-716-2
Downloads: 93629
Price: Free* [*Free Regsitration Required]
Uploader: Bagis

Root bend test which may be replaced by a face bend test in examining double-butt-welded test plates.

Welding shall be made in such a way that the weld zones have necessary strength for safety. However, this does not apply to those jiis zones that have passed radiographic examination.

Efficiency of Welded Joints 1. Welding of any parts which are liable to significant bending stress shall be avoided. The radiographic examination referred to in the exceptive clause of the preceding paragraph shall cover an area extending over at least 1. Holes in Weld zones 1.


Workmanship and Hydraulic Tests Section 1. For test plates less than 19 mm in thickness, longitudinal face bend and longitudinal root bend tests may be substituted for face bend and root bend tests, respectively.

Type of welded joint. Scope The welding of the any parts of First Class pressure vessels that are subject to jiw shall be in accordance with the provisions in this section unless such parts are free of any stress other than compressive one.

High-Precision, High-Quality Platework and Sheet Metal Machining

The efficiency of any welded joint in the preceding paragraph shall be equal to the appropriate one of the values specified in the right column of the following table for different types of welded joints listed in the left column thereof: If there is a 820 difference of elongation between the base metal of the test plate and that of the weld assembly or jia the weld assembly and weld metals, the mechanical test may be performed by the appropriate one of the procedures specified below:.


For test plates not 82700 than 19 mm in thickness, longitudinal root bend tests may be substituted for root bend tests except in examining double-butt-welded test plates, for which a longitudinal face bend test may be used in place of a face bend test.

No hole may be made in any weld zone including the adjacent areas within 6 mm from the edges of the welded metal. The allowable tensile stress of weld zones shall be the value that is obtained multiplying the figures calculated using the Article 3 or the Article 4 by the efficiency of the welded joint.