STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Vudonos Gokus
Country: Estonia
Language: English (Spanish)
Genre: Environment
Published (Last): 11 October 2014
Pages: 12
PDF File Size: 20.3 Mb
ePub File Size: 15.68 Mb
ISBN: 817-6-30424-652-1
Downloads: 90328
Price: Free* [*Free Regsitration Required]
Uploader: Dule

Reply 16 benaknoun Spain Posts. Eeeprom the fast way is to remove it from board and program it on the programmer ZIF spcket directly. Try to power up the board and do not connect pin 8 Vcc pin. Hi, i have connected the tool to the chip and adapter to the programmer.

That is depending on your circuit design. I think it should be SOIC8 mil chip.

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

Reply 9 ZLM Posts. Also, another question please about the same chip: Reply 5 ZLM Posts. What is your reprom on board?


Reply 2 benaknoun Spain Posts. Hi, it seems i’m doing something right then! When you uploading the image, only use letter and number as file name.

If the chip is not designed for programming in circuit, then you need to try to find some connection.

Chip is blank does this mean this chip is empty??? Reply 17 ZLM Posts. It should be able to open it by same software. To be honest though, the other adapter i bought, not sure what its for?? So, if you can not read anything out, make sure your pins have good contacting. Reply 4 benaknoun Spain Posts. That ewprom safe and fastest way.

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Reply 12 ZLM Posts. Reply 10 benaknoun Spain Posts. Hi, ok forget this chip, its damaged Reply 19 ZLM Posts. Reply 8 benaknoun Spain Posts.

Device blank check failed at eeeprom Reply 11 benaknoun Spain Posts. You need to find a way to test the data. Reply 15 ZLM Posts.


Eeprlm 3 ZLM Posts. What is exact part number? Reply 6 benaknoun Spain Eelrom. Hi, thanks for your reply, here are the numbers on the chip: All other pins are pin to pin connect to programmer socket.

Reply 18 benaknoun Spain Posts. The wire can be any wires, as long as you can solder it. Reply 14 benaknoun Spain Posts. You can save data as. Once the chip is blank, then you can load your data file and click on Write button to wrtie the data into chip. Reply 13 benaknoun Spain Posts. The “Device blank check failed ” means the chip is not a blank chip, there are some data in the chip.

Reply 7 Eeproom Posts. It is SOIC8 mil chip. What is your another adapter part number?

Then the ADP should be used. Which part number you selected in software?