CISCO MDS 9124 CONFIGURATION GUIDE PDF

Example Cisco MDS Switch Default Port License Configuration. switch# show port-license Available port activation licenses are 0. Cisco MDS Family Quick Configuration Guide. OL Using the Switch Setup Utility Verifying the Module Status CHAPTER. 3. Configuring. Note If a Cisco MDS or switch is used as a core switch, only a nontrunking F PortChannel is supported. Trunking is not supported on.

Author: Zulkisida Kajigal
Country: Brunei Darussalam
Language: English (Spanish)
Genre: History
Published (Last): 22 September 2011
Pages: 253
PDF File Size: 16.54 Mb
ePub File Size: 18.62 Mb
ISBN: 806-9-54271-706-6
Downloads: 47691
Price: Free* [*Free Regsitration Required]
Uploader: Akinom

Cisco Documentation team has internally re-written this as: You do not need to restart the fcdomain. Leave a Reply Cancel reply You cpnfiguration be logged in to post a comment.

Page Document states: Page Information is repeated twice on the same page: On the same page I find this block of text very vague and confusing: I am not mmds. The way its written sounds like if you have a large scale deployment where you need explicit LUN access control you can use proxy-initiator, but its really the opposite.

The autoreconfigure option takes immediate effect at runtime. Page shows with 8 base ports 8 licensed for growth. This is very redundant and can be combined into one bullet. Caution The span drop-threshold can be changed only if no span sessions are currently active on the switch. This should be made more clear.

  GUNNEBO SPEED GATES PDF

FCIP uses different ports. This however would be very nice to have in the documentation for IPS network simulator, an example showing complete configuration of Gigabit Ethernet interfaces and FCIP tunnels to go along with the Network Simulator.

This blog is mostly about my pursuits in Data Science. Reconfiguration as in changing of domains is always disruptive.

Obviously there was a part of this paragraph that got chopped off somewhere. This can mean several configuration tasks for each iSCSI host. Testing indicates that this is in fact enabled by default. I am not sure if this is valid.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata – Maximum Entropy

This is not correct as this does not work. There is no information contained in the example given that shows the configuration or enabling of FCIP interfaces. This is not true. Should be 8 base ports, which can goto 8 or 16 additional ports. These pages talk about an active mode of fcanalyzer.

You cannot mix ingress and egress interfaces in the same SPAN session. Certainly there is either a mistake in the wording or the example. Should say Step 1 Enable the mgmt 0 interface.

  ELEKTROLISIS LARUTAN KALIUM IODIDA PDF

Although it can be configured it has no effect. If you assign port number for physical portshow can you assign for ports ?

mdds The opinions expressed in this blog are entirely my own and should not be taken as the opinion of my employer. Have a few different people read that and I think you will see where I am coming from. Page Figure shows incorrect ip default-gateway Page States in one bullet: From time to time I will blog about other things of interest.

Unofficial Cisco MDS Release 3.x CLI Config Guide Errata

Proudly powered by WordPress. Previous blog entries also dealt with storage, compute, virtualization and professional services. If you enabled the autoreconfigure option on both switches before connecting the fabric, a disruptive reconfiguration RCF will occur.

I think what is meant here is: When you join two switches belonging to two different stable fabrics that have overlapping domains, the following cases apply: Then states two bullets configuratino